Charging The Battery; Operation; Safety Information; Controlling The Bath Lift - Invacare Aquatec Manuel D'utilisation

Operation

4.5 Charging the battery

The bath lift cannot be used while the battery is charging.
CAUTION Risk of electric shock

▸ Only recharge the battery in dry rooms.
!
IMPORTANT
▸ Only ever use the charger supplied (Aquatec®Beluga) to
charge the battery.
▸ Make sure that the voltage specifications shown on the
charger correspond to those of the power mains.
1. Insert the jack plug A of the charger E into the jack socket F on
the battery B.
2. Insert the mains plug C of the charger into a power socket.
The red indicator lamp D on the charger lights up until the battery is
charged.
It is not possible to overcharge the battery. The indicator
i
lamp goes out when charging is finished.
3. Disconnect the charger from the power socket.
4. Pull the jack plug of the charger out of the jack socket of the
battery.
5 Operation

5.1 Safety information

CAUTION

Overloading the bath lift can lead to damage to the device or
prevent lifting.
▸ Do not overload the bath lift and observe the specifications
on the identification label and in Section 10 Technical data
with regard to its load capacity.
!
IMPORTANT
▸ Always perform a visual inspection of the product for exter-
nal damage before each use.
▸ Recharge the battery completely before each
use.
It has a lift capacity greater than 1.5 times the nominal load.

5.2 Controlling the bath lift

The bath lift can be moved in the following directions:
The bath lift is controlled via the hand control.
With a fully charged battery, 22 bathing operations with
i
135 kg of load can be performed.
Beluga Bath Lift
11