Invacare Aquatec Manuel D'utilisation page 9

Setup and installation
!
IMPORTANT
▸ Ensure that the suction cups are mounted.
▸ Ensure that the battery is charged.
▸ Ensure that the spindle foot is inserted fully.
▸ When lifting, please remember: the seat weighs 8.6 kg, the
backrest 4.3 kg (without the battery).
▸ If the bathtub has a handrail, use the side flap diverter
(optional).
▸ Fold the side flaps outwards before raising the backrest.
1. Place the seat B on the bottom of the empty bathtub. Ensure that
the spindle foot retainer C is pointing towards the end of the bath-
tub opposite the drain A.
2. Fold the side flaps of the seat outwards.
3. Place the backrest C (without the battery) onto the seat so that
the slots D in the backrest fit into the hinges F of the seat plate E.
4. Press the spindle A into the catch B.
IMPORTANT Risk of damage

Damage to the product caused by the spindle foot slipping
out.
▸ Ensure that the spindle is pressed into the catch before
folding up the backrest.
▸ Once the backrest is folded up, ensure that the spindle foot
is in the spindle foot retainer and
locked.
5. Hold the backrest at the center of the head end and carefully swivel
it into the end position.
Beluga Bath Lift
9