Setup and installation
4
Setup and installation
4.1 Safety information
CAUTION
Risk of getting fingers caught when the lifting
scissors move
▸ Do not reach between the lifting scissors during assembly.
!
IMPORTANT
▸ Check the parts for transport damage before commissio-
ning and contact the authorized dealer if required.
▸ Ensure during assembly that the parts are positioned cor-
rectly with respect to one another.
4.2 Fitting the suction cups
Preparing for assembly
1. Place the seat on its side.
2. Press the red button A in the spindle foot retainer B.
The locking mechanism between the base plate and seat plate opens.
3. Carefully pull the base plate and the seat plate apart.
The seat is now lying in a stable position on its side.
Attaching the front suction cups
!
IMPORTANT
▸ The front suction cups have only one tab and a head for
insertion.
▸ The assembly procedure is the same for the right and left
side.
2
1. Press the red suction cup cover B from below out of the slotted
hole C in the base plate.
2. Apply a thin layer of commercial skin cream to the head of the
suction cup D.
▸ Lubricant film facilitates assembly.
i
!
IMPORTANT
▸ The tab with the toggle F must point backwards when you
insert it.
3. Insert the suction cup head from the bottom into the large opening
in the slotted hole.
4. Pull the suction cup head all the way to the front of the smaller
opening of the slotted hole.
5. Bend up the tab E and hook the toggle F into the groove A.
6. Push the red suction cup cover B from behind into the groove of
the suction cup D and into the slotted hole C in the base plate.
Beluga Bath Lift
1
F
7