Setting The Clock - Sony MHC-V800 Mode D'emploi

Setting the Clock

The built-in clock shows the time in the
display even if the power is off. You need
to set the clock to utilize the timer-activated
features of your system.
Use the buttons on the unit to do this
operation.
POWER m ON
1
2
1
Press TIMER.
2
Press CLOCK SET.
The "AM" and hour indication begin
flashing.
flashing
3
Set the current hour by turning the JOG
dial until the correct hour appears.
flashing
4
Press ENTER/NEXT.
The minutes indication begins flashing.
flashing
5
Set the current minute by turning the
JOG dial until the correct minute
appears.
flashing
6
Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
flashing
To check the time
Press DISPLAY/DEMO a few times.
The current time is displayed for eight
seconds.
4,6
To correct the clock setting
Repeat steps 1 through 6.
3,5
EN
7
Chapter 1: Setting Up