Automatic Ttl Fill-In Flash Mode; Automatic Flash Mode - Metz MECABLITZ 58 AF-2 digital Mode D'emploi

TTL
5.3 Automatic fill-in flash mode
With most camera models, the auto programme mode P and subject program-
me activate the automatic fill-in flash mode in daylight (see the camera's opera-
ting manual).
With the fill-in flash you can remove annoying shadows and achieve a balan-
ced exposure between motive and background in shots with backlight. A com-
puter-controlled metering system takes care of the appropriate combination of
shutter speed, working aperture and flash output.
Ensure that the frontlighting source does not shine directly into the lens, as this
will interfere with the camera's TTL metering system.
Ensure that the contre-jour light source does not shine directly into the
lens, as this will interfere with the camera's TTL metering system.
An adjustment or display for the automatic TTL fill-in flash mode on the flash
unit doesn't occur in this case.

5.4 Automatic flash mode

In the automatic flash mode A, the flash unit sensor
reflects back from the subject. The sensor
only measures the light for the time a flash is fired by the mecablitz. The flash is
cut off as soon as sufficient light has been emitted for correct exposure. The sen-
sor of the mecablitz has to be directed at the subject.
The maximum range is shown on the LC display. The shortest shot distance is
approximately 10% of the maximum distance range. The subject should be loca-
ted within the middle third of the distance range shown on the LC display to
allow the electronic system sufficient leeway for compensation.
110
measures the light that
has a coverage of about 25°, and
Setting procedure:
• Press the Mode button until „Mode" flashes on the
LC display.
A
• Set the flash mode using the
keys. The flash mode selected is then highlighted.
The setting takes effect immediately.
• Press the button to change the LC display back
to the normal view. If the button
the display will change back to the normal view after
about 5 seconds.
If the shot was properly lit, the correct exposure indica-
tion will flash „OK" for about 3 seconds (see 13).
5.5 Automatic flash mode
When shooting in automatic fill-in flash mode in daylight, the automatic flash
A
mode will automatically set a correction of between -1 and -2 f-stops to
compensate for flash exposures (see 6.3 and 10.5).
This has a graduated lightening effect on shadowy areas, which has a natural
appearance on the photograph.
TTL HSS
Mode
A
A
M
Set
and
A F 4.5
AZoom 35
2,0 m ISO 200
is not pressed,
Mode Para Sel