7.2 Automatic E TTL Fill-in flash mode
The automatic E TTL fill-in flash mode is acti-
vated by most cameras when the automatic
programme P is selected and by Vari or sub-
ject programmes during daylight (see camera
operating manual).
Fill-in flash mode overcomes troublesome
shadows and produces a more balanced
exposure between subject and background
with contre-jour shots. The camera's compu-
ter-controlled metering system sets the most
suitable combination of shutter speed, aper-
ture and flash output.
+
Ensure that the contre-jour light source does
not shine directly into the lens, as this will
interfere with the camera's TTL metering
system!
There is no setting or display for automatic
E TTL fill-in flash in the flash unit.
7.3 Manual flash mode
In the manual flash mode M , the flash unit
emits the full uncontrolled amount of light if
no partial light output has been selected. The
specific photographic situation can be taken
into account by adjusting the aperture set-
ting or by selecting a suitable manual partial
light setting. The setting area ranges from
P 1/1 to P 1/128 in
M HSS
P1/32 in
distance at which the subject is correctly lit
(see 5.2).
M
mode and P1/1 -
mode. The display shows the
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
mode of operation that was used last (e.g.
E TTL flash mode).
• Press the sensor button of the displayed
E TTL
mode of operation on the touch display as
-3,5 m
many times as it takes for the display for
0,3
selecting the mode of operation to appear.
m
Z
F4.0
35
OOM
m
EV
INFO
1
+
1/3
E TTL
• Press the
touch display and select
M
• Press the
MASTER
display.
• Set a suitable mode of operation on the
M
camera, e.g. M.
4.4 m
• Tap the shutter release to transfer data bet-
m
Z
F4.0
35
OOM
m
ween the flash unit and the camera.
INFO
1/1
sensor buttons on the
M
.
M
sensor button on the touch
159
k