Manual Flash Mode - Metz MECABLITZ 58 AF-2 digital Mode D'emploi

5.6 Manual flash mode

M
In the manual flash mode , the flash unit emits the full uncontrolled amount
of light if no partial light output has been selected. The specific photographic
situation can be taken into account by making adjustments to the aperture set-
ting or by selecting a suitable partial light setting.
Setting procedure:
A
Mode
M A • Press the
M HSS
LC display.
Set
• Choose the flash mode
arrows. The flash mode M is then highlighted. The
setting takes effect immediately.
M F 4.0
• Press the button
AZoom 35
6,1 m ISO 200
to the normal view. If the button
Mode Para Sel the display will change back to the normal view after
about 5 seconds.
Mode
button until „Mode" flashes on the
M
using the and
to change the LC display back
is not pressed,
Set partial light output:
• Press the Para button (Parameters ) until „P" flashes
on the LC display for partial light output.
• Set the desired light output (1/1-1/256) with the
+
–
and buttons.
The setting takes effect immediately.
• Press the button to change the LC display back
to the normal view. If the button
the display will change back to the normal view after about 5 seconds.
The mecablitz LC display will indicate the flash-to-subject distance required for a
correct flash exposure.
Some cameras only support the
camera is set to the manual operating mode M.
M F 4.0
AZoom 35
2,1 m P1/8
Para –
is not pressed,
M
manual flash mode when the
+
111