Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
door. Or install 3 'AAA' alkaline or rechargeable batteries following the polarity
as shown.
4.
Re-install the battery cover and belt clip (see chapter 8.1).
9
Charging batteries
When NiMh battery packs are installed, the desktop charger provides drop-in charging
convenience.
1.Put the desktop charger on a flat surface.
2.Plug the supplied adapter into the electric socket. Pay
attention to the mentioned voltage and compare this with
the indications of the power supply. Connect the low
tension plug at the end of the cable with the connector at
the backside of the desktop charger.
3.Put the PMR in the charger as indicated.
4.The charging LED will turn on if it's properly inserted
and charging.
It will take about 12 to 14 hours to fully charge the
batteries. There is no indication on the display when the
batteries are being charged.
The device can also operate with 3 x AAA NiMh batteries or with 3
x AAA Alkaline batteries.
3 x AAA Alkaline batteries cannot be charged with the charger.
10
Battery charge level
The battery charge level is indicated by the number of squares present inside the
battery icon on the LCD display.
•
+
•
+
•
+
•
+
When the battery charge level is low, a beep will be
heard.
11
Description
See folded cover page - illustration 1
Topcom Twintalker 5010
Battery full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
1.
Earpiece connector
2.
LCD display
3.
Volume up button
4.
Monitor / scan button MON /
5.
Up button
6.
Microphone
7.
Optional power supply connector
8.
Speaker
9.
Menu / on-off / unlock button
10.
Down button
11.
Call button
12.
Push to talk button
PTT
13.
Volume down button
14.
Power / transmission LED
15.
Antenna
12
LCD display information
See folded cover page - illustration 2
16.
Antenna icon
17.
Key lock icon
18.
Scan icon
19.
Roger beep icon
20.
CTCSS code
21.
VOX indication
22.
Channel number
23.
Battery charge level indication
13
Using the Twintalker 5010
If the segments and icons of the displays are shown in light grey
in this user guide, it indicates that they are blinking and/or
selectable.
13.1 Turning the unit on/off
To turn on:
•
Press and hold the
The unit will "beep" and the LCD display will display
the current channel.
To switch off:
•
Press and hold the
The unit will "beep" and the LCD display will turn
blank..
Topcom Twintalker 5010
/
9
-button
for 3 seconds.
9
-button
for 3 seconds.
5
Publicité
Table des Matières
