Topcom Twintalker 5010 Manuel D'utilisateur page 6

Topcom Twintalker 5010
13.2 Adjusting speaker volume
There are 15 levels of speaker volume
• Press the volume up button
to increase the speaker volume. The volume level is
displayed.
• Press the volume down button
speaker volume.
13.3 Receiving a signal
The unit is continuously in the receive mode when the unit is switched on and not
transmitting.
In order for other people to receive your transmission, they must
also be on the same channel and have set the same CTCSS code.
(See chapter 13.5 and 13.6)
13.4 Transmitting a signal
• Press and hold the PTT-button
LED will be on.
• Hold the unit in a vertical position with the microphone
10 cm from the mouth and speak into the microphone.
• Release the PTT-button
transmitting.
To check the channel activity use the monitor function (see chapter
13.7). The maximum transmitting time is limited to 1 minute.
Release and press PTT-button
13.5 Changing channels
• Press the
the channel.
6
3
in stand-by-mode
13
to decrease the
12 to transmit. The TX
12 when you want to stop
to restart transmitting.
12
5 10
-button or -button to change
13.6 CTCSS (Continuous Tone Coded Squelch System)
The 2 digit CTCSS code corresponds to a specific tone frequency the radio emits.
Two users, with the same channel and CTCSS set can hear one another. They will
not be able to hear anyone else on the channel unless the other radios have the same
exact CTCSS code enabled. The Twintalker 5010 has 38 CTCSS codes available.
• Press the
flashes on the display.
• Press the
change to another code.
• Press the PTT-button
stand-by mode.
• It is recommended to set a CTCSS code for each channel.
This way you will have minimum interference from other
users on the same channel.
• To disable CTCSS code, set the code to '0'.
If no button is pressed within 5 seconds during setting, the unit
will return to standby.
13.7 Monitor
You can use the monitor feature to check for weaker signals in the current channel.
• Press and hold the -button
MON\
• Release the -button
MON\
13.8 Call tones
A call tone alerts other users that you want to start talking to.
13.8.1 Setting the call tone
The Twintalker 5010 has 10 call tones
• Press the
• Press the
to another call tone. Select '0' to disable the call tones.
• Press the PTT-button
stand-by mode.
13.8.2 Sending a call tone
Press the button briefly. The call tone will be transmitted on the set channel.
11
9
-button , the current CTCSS code
-button 5 or -button
12 to confirm and return to
4
to activate channel monitoring.
4
to stop monitoring.
-button 9 two times.
5
-button or -button
to confirm and return to
12
Topcom Twintalker 5010
10
to
10
to change