Using Rechargeable Batteries; Headset Use; Sending Call Tones; Flashlight - Topcom TwinTalker 5000 Manuel D'utilisateur

All manuals and user guides at all-guides.com
HL_TT5000.book Page 8 Tuesday, May 13, 2003 10:18 AM
ENGLISH

5.8. Using rechargeable batteries

Important: Do not charge this unit using an AC/DC ADAPTER with regular
"AAA" alkaline batteries installed. Only use the optional AC/DC ADAPTER
with "AAA" rechargeable batteries (not included).
To use the PMR with an AC/DC ADAPTER and rechargeable batteries do the following:
1. Insert four (4) "AAA" rechargeable batteries (not included).
2. Plug the 12 V DC / 100 mA ADAPTER (not included) into the CHARGER JACK at
side of the unit and turn it ON by pressing the POWER button.
NOTE: The unit cannot transmit while the batteries are being charged. It
takes approximately 8 to 10 hours to fully charge the batteries.

5.9. Headset use

You can operate the PMR using a headset (not included).Plug the headset into the EAR/
MIC jack

5.10. Sending Call Tones

You can use Call Tones to alert the other user to identify yourself. You can also use Call
Tones to signal the beginning or the end of a transmission.
1. Press and release the CALL button. The CALL TONE continues for 3 seconds.
2. Your CALL TONES will transmit to nearby receivers set to the same channel.

5.11. Flashlight

Press and hold the Flashlight button to activate the light.

6. SPECIFICATIONS

Channels 8 Channels
CTCSS Sub-channel 38 for each Channel
Output Power (TX) Output Power: 0.5W (Maximum)
Range Up to 3 Km (open field)
Charging adaptor 12 V DC / 100 m A
8 Topcom Twintalker 5000