Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TOPCOM TWINTALKER 1302
10
LCD DISPLAY INFORMATION
11
BATTERY CHARGE LEVEL/LOW BATTERY INDICATION
The BATTERY CHARGE LEVEL is indicated by the number of squares present inside the BATTERY icon on the LCD
Screen.
SC
TX RX
When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries need to be
replaced or recharged.
12
CHARGING RECHARGEABLE BATTERIES
The PMR can be used with 3 alcaline or rechargeable NiMh AAA batteries.
Only use the AC/DC ADAPTER with "AAA" rechargeable batteries. Do not try to charge
this unit when regular "AAA" alkaline batteries are installed.
When using rechargeable batteries you can use the optional adapter to charge.
• Insert 3 "AAA" rechargeable batteries.
• Plug the small plug of the 7,5 V DC / 200 mA adapter into the SPK/MIC/CHG jack and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries properly. There is no
charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.
13
USING THE TWINTALKER 1302
13.1 TURNING THE UNIT ON/OFF
•
To activate; press and hold
•
To switch off; press and hold
6
a.
Channel number
b.
Speaker Volume
c.
RX icon - Displayed when receiving a signal
d.
TX icon - Displayed when transmitting a signal
e.
Lock icon - Displayed when the keypad is locked.
f.
Battery charge level indicator
g.
Scan icon - Displayed when scan mode is active
Battery Full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
Dispose of batteries at a designated battery disposal unit and
not in the household waste. Do not short-circuit & dispose of in
fire. Remove the batteries if this device is not going to be used
for a long period.
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
TOPCOM TWINTALKER 1302
Publicité
Table des Matières
