Getting Started; Installing/Removing The Belt Clip; Included In The Package; Battery Installation - Topcom Twintalker 5010 Manuel D'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Topcom Twintalker 5010
these devices use free frequency bands (channels), all devices in operation share
these channels(total 8 channels). Therefore, privacy is not gusaranteed. Anybody
with a PMR set to your channel can overhear the conversation. If you want to
communicate (transmitting a voice signal) you need to press the PTT-button
Once this button pressed, the device will go into transmit mode and you can speak
into the microphone. All other PMR devices in range , on the same channel and in
standby mode (not transmitting) will hear your message. You need to wait until the
other party stops transmitting before you can reply to the message. At the end of each
transmission the unit will send a beep if the roger beep is enable (see chapter 13.15).
To reply, just press the PTT-button
If 2 or more users press the PTT-button
receiver will receive only the stongest signal and the other
signal(s) will be supressed. Therefore you should only transmit a
signal (press PTT-button
The range of radio waves is strongly affected by obstacles such as
buildings, concrete/metal structures, the unevenness of the
landscape, woodland, plants, ... This implies that the range
between two or more PMR's may in some extreme cases be
restricted to a maximum of a few tens of meters. You will soon
notice that PMR works best when there is a minimum of obstacles
between users.
7

Included in the package

2 x Twintalker 5010
2 x Belt clip
1 x Duo charger
1 x Power adapter
2 x NiMH (3 x AAA) battery pack
ECO User guide
4
and speak into the microphone.
12
at the same time the
12
) when the channel is free.
12
8

Getting started

8.1

Installing/removing the belt clip

12
.
1.
To install the belt clip, align the pin with the hole in the backside. Gently push
until it clicks into position.
2.
To remove the belt clip from the unit, push the belt clip (a), while pulling the
clip away from the unit (b).
8.2

Battery installation

1.
Remove the belt clip (see chapter 8.1).
2.
Pull the battery cover tab (c) and gently remove the battery cover.
3.
Install the rechargeable battery pack following the polarity as shown. The
metal contacts should face outwards from the radio to connect on the battery
Topcom Twintalker 5010

Publicité

Table des Matières
loading

Table des Matières