Festo ASI−EVA 2E2A−Z Série Manuel D'installation page 24

Please note the following:
The length of the load voltage cable (depends on the
current consumption and the fluctuations in the load
voltage).
Fit Festo cable caps ASI−KK−FK or cable sleeves ASI−KT−
FK to open ends of cables. In this way you can avoid
leakage currents and comply with protection class
IP65.
3.7 Configuring the additional power supply (load voltage)
Setting
With load voltage
(factory setting)
Without load voltage
(Seal the 24V DC" con
nection with blanking plug
type ASI−SD−FK−BL)
1)
Black = pressed (only the DIL switch settings shown are
permitted. Warning in section 1 must be observed.)
2)
The outputs/valves are provided with power via the addi
tional supply
3)
The outputs/valves are provided with power via the AS−In
terface bus
24
DIL switch setting
2)
3)
Festo ASI−EVA−...−2E..A−Z 0401b English
1)
1, 2: Off
On
3, 4: On
Off
1, 2: On
On
3, 4: Off
Off