The Video Equalizer Function; Set Up The Video Eq; Turning The Equalizer On/Off - Pioneer SVM-1000 Mode D'emploi

THE VIDEO EQUALIZER FUNCTION

THE VIDEO EQUALIZER FUNCTION
Rotating the channel equalizer dial normally applies equalizer effects on audio only. However, by using the VIDEO EQ function, effects
can be applied to video as well.
VIDEO EQ

SET UP THE VIDEO EQ

1 Hold down the VIDEO EQ button.
This initiates the equalizer setup mode.
2 Touch each applicable button.
Touch each applicable button on the screen to operate the
VIDEO EQ setup.
• Whenever power is first turned on, default settings are as
follows:
HI: CONTRAST
MID: HUE
LOW: SATURATION
34
En
HI
10 10
9 9
8 8
7 7
6 6
5 5
4 4
3 3
2 2
1 1
0 0
VIDEO EQ SET UP
Use to make the video effects change
simultaneously when using the equalizer.
OFF: Disables the VIDEO EQ.
R: Used when assigning parameters that
change the red elements of the VIDEO
EQ.
Used when assigning parameters.
G: Used when assigning parameters that
change the green elements of the VIDEO
EQ.
Used when assigning parameters.
B: Used when assigning parameters that
change the blue elements of the VIDEO
EQ.
HUE: Used when assigning parameters
that change the hue of the VIDEO EQ.
CONTRAST: Used when assigning
parameters that change the contrast of
the VIDEO EQ.
SATURATION: Used when assigning
parameters that change the saturation of
the VIDEO EQ.
3 Touch [EXIT].
This ends the equalizer setup mode.

TURNING THE EQUALIZER ON/OFF

1 Press the VIDEO EQ button.
The VIDEO EQ settings will alternate between enabled/
disabled each time the button is pressed.