Residual Risk; Emergency Procedure; General Safety Rules - Güde MIG 155/6 W Traduction Du Mode D'emploi D'origine

ENGLISH
24
The valid accident prevention regulations must be
adhered to strictly..
The welding device may not be used:
• in rooms that do not have sufficient ventilation
• in a damp or wet environment,
• in an explosive environment,
• to defrost pipes,
• close to people who have a pacemaker and
• close to flammable materials
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
Please note that our equipment has not been desi-
gned for commercial, craft or industrial use. If the
equipment is used in commercial, craft or industrial
operation or for similar activities, we cannot assume
any liability.
Requirements for operating staff
The operating staff must carefully read the Opera-
ting Instructions before using the appliance.
Since the use of the device if handled incorrectly can
entail considerable risks, only knowledgeable persons
may be entrusted with the use of it.
The operator must be appropriately trained in setting
up, operating and using the machine.
Qualification: Apart from the detailed instructions
by a professional, no special qualification is necessary
for appliance using.
Minimum age: Persons over 18 years of age can
only work on the appliance. An exception includes
youngsters trained in order to reach knowledge
under supervision of the trainer during occupational
education.
Training: Using the appliance only requires corres-
ponding training by a professional or the Operating
Instructions. No special training is necessary. The
operator is responsible for accidents or risks to third
parties.

Residual Risk

Despite the observance of the operating instructions
there still may be some hidden residual risks.
Even when the welding device is operated properly,
there are still residual risks associated with the use
of the device FThe following hazards may arise in
connection with the construction and design of this
welding device:
• Eye injuries as a result of glare,
• Touching hot parts of the device or the workpiece
(burn injuries),
• In the event of improper protection, the risk of
accidents and fire as a result of spraying sparks or slag
particles,
• Emissions which have adverse health effects as a
result of smoke and gas, in the event of lack of air
and/or insufficient extract ventilation in closed rooms.
Reduce the residual risk by operating the welding de-
vice carefully and properly and follow all instructions..

Emergency procedure

Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down.
If you seek help, state the following pieces of infor-
mation
1. Accident site,
2. Accident type,
3. Number of injured persons,
4. Injury type(s)

General Safety Rules

WARNING! Electric shock! There is a risk of
an injury caused by electric shock!
WARNING
Read all safety warnings and all instructions. Failu-
re to follow the warnings and instructions may result
in electric shock, fire and/or serious injury. Save all
warnings and instructions for future reference.
Keep your work area clean and tidy. Untidy work-
places and workbenches increase the risk of accidents
and injuries.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
The device and packaging are not toys.
Comply with the local injury prevention regulations
and safety regulations in the work area.
Please note that permissible uses for the tool could
be limited by national regulations.
Do not use accessories which are not specifically desi-
gned and recommended by the tool manufacturer.
The device may not be placed in a narrow space or
directly against a wall during functional operation.
Only in this way can it be ensured that sufficient air
gets into the opening slit.