Güde MIG 155/6 W Traduction Du Mode D'emploi D'origine page 33

Whilst working, the welder's entire body must be
protected against radiation and burns by means of
the clothing and face protection.
Gauntlets made from a suitable material (leather)
must be worn on both hands. These must not be
damaged.
Suitable aprons must be worn to protect the clothing
against flying sparks and burns. If the nature of the
work, e.g. overhead welding, requires this, a protec-
tive suit must worn and, where necessary, this must
also include suitable head protection.
The protective clothing which is used, as well as all
the accessories, must be compliant with the "Personal
Protective Equipment" Regulation (2016/425).
Class A (IEC 60974-10):
If you intend to use the apparatus in residential sur-
roundings supplied by the low voltage mains supply,
an electromagnetic filter may be required to suppress
electrical disturbance to a level where they will no
longer be a nuisance to the user.
The apparatus may be used in industrial or other
areas where power is not supplied by municipal LV
mains.
Class A apparatus are not intended for use in resi-
dential areas where power is supplied via municipal
LV mains, since unfavourable power conditions may
cause interference.
As a user, you must make sure, after consultation with
your energy provider, if necessary, that your point of
connection on which the machine is to be operated
meets the requirements above.
The user is responsible for faults arising from the
welding.
SYMBOLS
Caution!
Read the operating instructions
to reduce the risk of injury.
The appliance must be stored in a dry
place and protected from frost.
Keep the machine out of reach of
children.
Never expose tool to rain.
Wear personal protective equipment.
Use a welding mask!
Special welding gloves to be worn at all
times.
Wear safety cut through resistant shoes
with safety sole and steel toe !
Protective apron to be used
Unplug the machine before any work
on it.
Pressure bottle to be secured by chain
Warning against dangerous
voltage
Risk of explosion
Warning against toxic fumes!
Keep dry at all times. Never expose tool
to rain.
Keep distance of persons Observe to keep
out of dangerous zone
~
Single-phase transformer with rectifier
1
MIG (welding, metal-inert-gas)
MAG (welding, metal-active-gas)
Suitable for welding with an increased
electric risk.
Single-phase alternating current with
rated frequency of 50 Hz
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
ENGLISH
29