Güde MIG 155/6 W Traduction Du Mode D'emploi D'origine page 31

Do not weld on containers, vessels or pipes which
have contained flammable liquid or gases.
Wood, sawdust, „varnishes", petrol, kerosine, natural
gas, acetylene, propane and similar flammable
materials must be removed from the place of work
and the surrounding area or protected against sparks
flying away.
Caution! Fire hazard due to spraying
sparks
If the molten or burning metal or slag particles
land on flammable substances, these may ignite
and cause a fire. Therefore, remove all flammable
objects from your workspace before commencing
welding work. Keep a suitable fire extinguisher
to hand.
In this regard, take the following materials into
consideration in particular:
• Paper
• Rags
• Textiles
• Wood and wood fibres
• Rubber
• Plastic
• Petrol
• Oils
• Tar-like substances
• Paints and solvents
No welding or cutting on vessels and pipes if they
are open, containing materials able to explode due
to heat or moisture or able to cause other dangerous
reactions.
Caution! Explosion hazard and fire hazard
due to welding sparks
Both the welding sparks and the welding point
itself, which is heated to high temperatures, may
cause explosions. Therefore, do not use the device
in a potentially explosive environment where
substances such as flammable liquids, gases and
paint mist are present.
Please note:
• When the welding device is in operation, do not
place the burner on the welding device itself nor
on any other electrical device.
• Before finishing your welding work, do not touch
the contact tip itself nor any other metal objects
which touch the contact tip.
• Disconnect the power supply to the device im-
mediately after completing your welding work.
• It is essential to ensure that no cables become
wrapped around your body.
• It is essential to ensure that you are not within
the welding circuit. The burner and earth must
always be on the same side.
No welding or cutting on closed vessels and pipes.
Never use the welder to defrost frozen pipes.
The respective national guidelines and laws must
be observed when carrying out welding work. This
relates, in particular, to the respective accident pre-
vention provisions.
The footprint of the welding device can be inclined
up to 10° to the horizontal. In the most inconvenient
position the device must not fall over. If necessary, it
has to be secured properly.
Ensure that the welding device cannot fall over in the
event you place it on a tilted surface.
In order to prevent damage to the device, it must only
be transported in an upright position.
The gas bottle must necessarily be secured against
falling.The welder must never be lifted together
with the gas bottle. Special regulations apply to the
transport of gas bottles.
Handling of gas bottles.
Make sure the gas bottles are used and stored in
rooms with sufficient air inlet and outlet.
A leaking gas bottle may reduce the share of oxygen
in the inhaled air and therefore represent a risk of
suffocation.
Before use, make sure the gas bottle contains gas
designed for the work being done.
ENGLISH
27