Maintenance And Cleaning - Güde GPS 3,6V LI-ION Traduction Du Mode D'emploi D'origine

adjust the operating height and tighten the screw
coupling again.
• Plug the control cable of the guide rod into
appropriate outlet on the back of the handle (E)
• To start the grass shears, you must first press the
switching bar and then the switch-on button on the
guide rod.
• The grass shears in the guide rod can now be
operated.
Knife change
Make sure the knife cover is fitted, which prevents
cutting injuries!
When changing the grass knife for a shrub knife you must
remove the bottom cover (G) of the grass knife. To that
end, the deflected cover with an arrow (pic. G) needs to be
lifted and pulled out 6-8 mm in the operating handle
direction. The cover can now be taken out.
Replace the grass knife with the shrub knife. The eccentric
of the drive wheel (H a) must bite exactly into the fixture (H
b).
Moreover, it may be necessary to slightly adjust (shift) the
knife fixture so that the knife matches the drive wheel.
The knife hole must exactly match both centring pins (H c).
The knife head can be fixed in several positions by
pressing the locking button (I).

Maintenance and cleaning

Install the knife cover before all works on the electric
appliance (e.g. maintenance, tool change, etc.) and
during its transport and storing!
There is a risk of injury associated with unintentional
pressing the on/off button.
Keep the electric appliance and any ventilation slot
clean to ensure good and safe operation.
If the accumulator does not work anymore, please contact
our customer service department.
13