Programme
P4
89 Min Intensiv
P5
30 Min
P6
Gläser / Verre
P7
Extra Silent
P0
Machine Care
1) The pressure and the temperature of the water, the variations of the mains supply, the
options and the quantity of dishes can change the values.
5.2 Information for test
institutes
For all the necessary information for test
performance, send an email to:
6. SETTINGS
6.1 Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter user mode.
Settings available in the user mode:
• The level of water softener according
to the water hardness.
• Activation or deactivation of the rinse
aid empty notification.
• The level of rinse aid according to the
required dosage.
• Activation or deactivation of the
acoustic signal for the end of a
programme.
• Activation or deactivation of AirDry.
As the appliance stores the saved
settings, there is no need to configure
it before every cycle.
Water
1)
(l)
12.9
10
12 - 14
12 - 13
10
Energy
(kWh)
1.14
0.9
0.8 - 1.0
1.1 - 1.3
0.86
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode
the following way:
Press and hold Reset until the appliance
is in programme selection mode.
How to enter user mode
Make sure the appliance is in
programme selection mode.
To enter the user mode, press and hold
simultaneously
indicators
,
,
and the display is blank.
ENGLISH
Duration
(min)
89
30
82 - 92
230 - 250
60 - 70
and
until the
,
and
flash
9