Cruise Control; Assembly Procedure - Skoda 3T0 035 623 Instructions De Montage

CRUISE CONTROL

The accessories are intended for professional fitting. Škoda Auto recommends the fitting to
be carried out by its contract partners.
The set can bne mounted in vehicles Škoda Octavia (1Z), Superb (3T) and Yeti (5L) ma-
nufactured from CW 22/2010.
Important. The set is designed primarily for vehicles equipped with back wiper. The set
can be also used in vehicles without the back wiper but the control of the back wiper
on the switch underneath the steering wheel will be functionless. This fact has no effect
on correct function of the vehicle but the customer must be notified yet prior to the set
assembly.
Cruise control can be activated only in combination with certain types of steering
column electronic control units. List is available on Fig. 6. If the steering column elec-
tronic control unit is replaced with another, the customer bears the costs of it.
List of parts (fig. 1)
Part name
Change-over switch below the steering wheel
with the control of the cruise control
Interconnecting wire
Tightening tape
Protecting tube
Fastener

Assembly procedure

Perform the disassembly and reassembly of individual parts according to Škoda workshop
manual. During the fitting, the car battery must be disconnected.
- 2 -
- Replace the existing switch under the steering wheel with the Cruise Control switch (A) from
the set 3T0 035 623 or 3T0 035 623A (depending on the equipment of the car) - applies for
all vehicles Škoda Octavia (1Z), Superb (3T) and Yeti (5L).
(see Body – fitting works, Circuit diagrams, Fitting points)
At removing and re-fitting the steering wheel, it is indispensable to observe the posi-
tion of the steering wheel against the steering wheel shaft.
Note – The control unit of the electronics of the steering column and the switch module un-
der the steering wheel are sealed up with a yellow self-adhesive tape in some cars. This tape
is informative only, can be damaged and does not relate to warranties.
- 3, 4, 5 -
- applies for vehicles Škoda Superb (3T) - using wire (B) interconnect the terminal board of
the electronics of the steering column (T16s/ PIN 5) with the terminal board of the engine
control unit (distinguished according to the type of engine, see Fig. 3).
Pieces Position
1 A
1 B
13 C
1 D
1 E
GB