Figure 4 Connecting Leads To The Terminal Block - Federal Signal Commander 371LEDX-120 Manuel D'installation Et D'entretien

Feu tournant pour endroits dangereux
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Figure 4  Connecting leads to the terminal block
DIECAST
BASE
FACTORY-SUPPLIED
LEADS FROM
TERMINAL BLOCK
3. Route the supply wires (10 AWG to 16 AWG) into the light
housing.
4. Strip a maximum of 0.28 inch (7 mm) of insulation from
the ends of the power leads. Connect the wires to the
terminal block by inserting the stripped ends of the wires
into the connectors as far as they can travel.
Installation and Maintenance Instructions
Model 371LEDX-120 Rotating Light
PLASTIC DOME
DIECAST RING
#10 PHILLIPS
SCREW (3)
TERMINAL
BLOCK
290A7466
13

Publicité

Table des Matières
loading

Table des Matières