Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.3
Emission levels
Levels determined in accordance with EN 60745 are
typically:
Screwing with impact
Sound pressure level
Noise level
Uncertainty
Screwing and drilling without impact
Sound pressure level
Noise level
Uncertainty
CAUTION
When working with noise
Damage to hearing
Always use ear protection.
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Drilling in metal
Screwing
Tightening screws and nuts
with maximum size
3
Technical data
Cordless impact screw driver
Motor voltage
Idling speed
Impact rate
Max. torque
Chuck clamping range
Drill diameter max.
Max. screw diameter in spruce
Tool holder in drill spindle
Weight without battery pack with Centrotec
* electronically limited
L
= 93 dB(A)
PA
L
= 104 dB(A)
WA
K = 3 dB
L
= 68 dB(A)
PA
L
= 79 dB(A)
WA
K = 3 dB
(vector sum for three
h
a
< 2,5 m/s
h
K = 1,5 m/s
a
= 3,0 m/s
h
K = 1,5 m/s
a
= 11,3 m/s
h
K = 3,0 m/s
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
2
Symbols
Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
Wear ear protection.
Wear protective gloves.
Wear protective goggles.
2
2
Do not throw in the household waste.
2
2
Operating mode Impact screw driver
2
2
Operating mode Screwing/Drilling without
impact
Hard material (metal)
TI 15
0 - 2600 rpm
2400 - 3600 rpm
1,5 - 13 mm
Wood
Metal
Up to 8x160 mm
GB
TI15
14,4 V
100 Nm*
13 mm
10 mm
1/4 ''
1,2 kg
13
Publicité
Table des Matières
