Empire Comfort Systems Archway 1700 Manuel D'installation Et D'opération page 56

3. Align the holes of the faceplate extension (A) with the holes in the faceplate panels B, C
and D. Screw them using bolts (G) and nuts (H) provided.
D
4. Center the insert into the fireplace opening.
If necessary, adjust the height of the insert using the levelling bolts (M) on each side
of the insert until the faceplate is properly seated on the floor of the hearth extension.
5. Align the notch in the faceplate extension with the bolt (J) welded to the air jacket located and
slide the faceplate assembly just over the washer (K). Then push towards the fireplace.
Once the faceplate is in place, secure the assembly by tightening nut (L) using a 7/16" (11 mm)
6.
open wrench.
K
A
C
J
L
6x
G
B
H
6x
M
2x
Page 43