Replacing Components; Auger Motor - England's Stove Works 25-PAH Manuel D'installation Et D'utilisation

Auger Motor
1. Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down. Also, make sure the hopper is empty before attempting to
remove or replace the auger motor assembly.
2. Remove the back panel of the unit; before loosening any bolts, detach the wiring
harness from the auger motor.
3. Locate the auger motor assembly at the rear of the stove, and begin by loosening the
two allen set screws on either side of the cast iron auger motor coupler.
4. Slide the auger assembly out of the tube.
5. Next, remove the four screws which hold the cast iron auger motor coupler to the auger
motor, using a 5/16" wrench. Slide the cast iron auger motor coupler and the steel
spacer plate off of the auger motor.
6. Loosen the allen set screw which holds the steel auger coupler to the auger motor
output shaft, and remove the steel auger coupler, as well as the rubber vibration
dampener.
7. Reinstall the parts in reverse order on the new auger motor, being careful not to over‐
tighten the bolts which hold the cast iron auger coupler to the auger motor.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
REPLACING COMPONENTS
33