Axis A1001 Guide D'installation page 44

AXIS A1001 Network Door Controller
- SmartIntego: Click the link to view the hardware pin chart or click Click
here to select wireless gateway and configure doors to complete the
configuration, see How To Configure SmartIntego on page 45.
How to create a new hardware configuration with elevator control (AXIS
A9188)
Important
Before creating a HW configuration you need to add a user in AXIS A9188 Network
I/O Relay Module. Go to the A9188 web interface > Preferences > Additional device
configuration > Basic setup > Users > Add > User setup.
Note
Max 2 AXIS 9188 Network I/O Relay Modules can be configured with each Axis Network
Door Controller
1. In A1001, go to Setup > Hardware Configuration and click Start new hardware
configuration.
2. Enter a name for the Axis product.
3. In the list of peripherals, select Elevator control to include an AXIS A9188 Network
I/O Relay Module and click Next.
4. Enter a name for the connected reader.
5. Select the reader protocol that will be used and click Finish.
6. Click Network Peripherals to complete the configuration see or click the link to go to
the hardware pin chart.
Add Assa Aperio
Before adding a wireless door to the system it needs to be paired with the connected Assa Aperio
communication hub, using Aperio PAP (Aperio programming application tool).
To add a wireless door:
1. Go to Setup > Hardware Reconfiguration.
2. Under Wireless Doors and Devices click Add door.
3. In the Door name field: Enter a descriptive name.
4. In the ID field under Lock: Enter the six-character-long address of the device that you
want to add. The device address is printed on the product label.
5. Optionally, under Door position sensor: Choose Built in door position sensor or
External door position sensor.
Note
If using an external door position sensor (DPS), make sure that the Aperio lock device has
support for door handle state detection before configuring it.
TM
doors and devices
44