Assign An Ip Address - Axis A1001 Guide D'installation

page de 214

/ 214
Matières
Table des Matières
Signets

Les langues disponibles

AXIS A1001 Network Door Controller

If you do not know the IP address, use AXIS IP Utility to locate the product on the

network. For information about how to discover and assign an IP address, see Assign

an IP Address on page 38. This information is also available from the support pages

at axis.com/support

3. Enter your username and password. If this is the first time the product is accessed, the

root password must first be configured.

4. AXIS Entry Manager opens in your browser. The start page is called the Overview page.

How to access the product from the internet

A network router allows products on a private network (LAN) to share a single connection to the

internet. This is done by forwarding network traffic from the private network to the internet.

Most routers are pre-configured to stop attempts to access the private network (LAN) from the

public network (internet).

If the Axis product is located on an intranet (LAN) and you want to make it available from the

other (WAN) side of a NAT (Network Address Translator) router, turn on NAT traversal. With

NAT traversal properly configured, all HTTP traffic to an external HTTP port in the NAT router is

forwarded to the product.

How to turn on the NAT-traversal feature

•

Go to Setup > Additional Controller Configuration > System Options > Network >

TCP/IP > Advanced.

•

Click Enable.

•

Manually configure your NAT router to allow access from the internet.

See also AXIS Internet Dynamic DNS Service at www.axiscam.net

Note

• In this context, a "router" refers to any network routing device such as a NAT router,

network router, internet gateway, broadband router, broadband sharing device, or a

software such as a firewall.

• For NAT traversal to work, NAT traversal must be supported by the router. The router

must also support UPnP