Set Date And Time - Brecknell B140 Mode D'emploi

3.
4.

5.5 Set Date and Time

If a hardware RTC and backup battery are installed you can set the correct date and
time. The date and time will run unless the scale is reset. It will then revert to default
settings and date and time will need to be reset.
1.
2.
3.
B140 Counting Scale User Instructions
Press the 1, 2 or 3 numerical key to change the byte format (Default setting:
8N1). When the wanted byte format is displayed, press the Enter key to save
the setting ...
232.cft (RS232 output format) is displayed in the COUNT window.
x (x=0-1-2-3) is displayed in the WEIGHT window. This means that the
RS232 output format is currently set to x.
X=0: disable RS232 output
X=1: output after scale is stable
X=2: output after Print key is pressed
X=3: output after scale is stable or Print key is pressed
Press the 0, 1, 2, or 3 numerical key to change the output format (Default
setting: 2). When the desired byte format is displayed, press the Enter key to
save the setting ...
The scale restarts and returns to normal mode.
In normal mode, press and hold the ON/OFF and PLU5 keys at the same time
until ...
SEtUP is displayed in the PIECE WEIGHT window.
dAtE (date) is displayed in the COUNT window.
xx.xx.xx (YY.MM.DD) is displayed in the WEIGHT window. This means
that the current date is xx.xx.xx.
Use the numeric keys to change the date number and press the Enter key to
save the setting ...
tiME (time) is displayed in the COUNT window
xx.xx.xx (HH.MM.SS) is displayed in the WEIGHT window. This means
that the current time is xx.xx.xx.
Use the numeric keys to change the time and press the Enter key to save the
setting ...
The scale returns to normal mode.
27