Set And Recall A Preset Tare Weight; Counting Using Upper And Lower Count Limits - Brecknell B140 Mode D'emploi

4.
Piece weight can not be set to zero.

3.2.5 Set and Recall a Preset Tare Weight

You can store two preset tare weights; one each in the PT1 and PT2 memories. These
can be recalled at any time. Follow these steps:
1.
2.
3.
4.

3.2.6 Counting Using Upper and Lower Count Limits

You can do counting with an alarm to tell you when you have an acceptable number of
items on the scale. This can be handy when you want to repeatedly fill bags to the same
count. Use the instructions below to set an upper count limit and a lower count limit.
When your counts fall between these numbers (inclusive) a beeper sounds to let you
know you've hit your target number.
1.
2.
3.
4.
B140 Counting Scale User Instructions
If you want to change a stored piece weight, press the Pwt key and input the
piece weight you want, then use step
new piece weight.
Press and hold PT1 or PT2 key until ...
PT1/PT2 is shown in the COUNT window. Gross weight is shown in the
WEIGHT window.
Use the numeric keys to input a tare weight and press Enter to save. While
entering the value, if you make a mistake, press the Clear key to delete.
To recall a stored preset tare from memory, press PT1 or PT2 key.
The preset tare weight in PT1 or PT2 memory becomes the active tare
weight. The Tare annunciator lights up except if the preset tare is 0.
To clear a stored tare weight, in step 1, input 0 then press Enter to accept.
Turn the scale on and press the Zero key, if necessary. Be sure the scale is
displaying weight in your preferred unit of measure. Press the Units key, if
necessary.
Use sampling or enter a known piece weight to set a piece weight.
Press the Hi/Lo key ...
Hi. PCS is shown in the PIECE WEIGHT window and a number appears
in the COUNT window.
Press the Clear key to clear the number from the COUNT window. Key in the
upper acceptable count of items. (You can set the upper and lower limit to the
same number to have the alert beeper sound just on that value.) Press the
Enter key to accept this number ...
Lo. PCS is shown in the PIECE WEIGHT window and a number appears
in the COUNT window.
1 to replace the stored piece weight with
19