SATA air vision 5000 Mode D'emploi page 83

Remove facial seal.
■ Detach the hygiene insert [6-3] from the hooks behind the head fixation
[6-1] and from the visor hooks [6-4].
Attach new facial seal
Notice!
The facial seal is designed symmetrically and can be used on both
sides. For an easy alignment, start attaching at the visor tip.
■ Attach new facial seal [6-5] to the visor hooks [6-4].
■ Insert the flaps of the facial seal [6-2] turned behind the head straps.
■ Pay attention to the rotational direction!
■ Fix the tabs to the hooks of the hood shell [6-1].
10.2. Exchange visor foil.
Impaired hazard detection
Any soiling of the visor foil can impair the field of vision significantly.
→ Clean visor foil regularly.
→ Replace visor foil.
■ Detach the visor foil [7-1] from the protruding tabs [7-2] to remove it
from the visor bolts [7-4].
■ Check the sealing edge [7-3] of the visor for soiling, clean carefully if
necessary. Avoid damages.
■ Put the new visor foil [7-5] in position and press against the visor bolts.
Make sure that the visor foil fits properly.
10.3. Exchange visor bolts.
The visor bolt [8-1] is inserted through a hole in the visor and fastened
with a spreading device [8-2].
Remove visor bolt.
■ Use a pin punch 3 mm to remove the expanding pin.
■ Remove the visor bolt.
Attach new visor bolt.
■ Insert the new visor bolt.
■ Push in the spreading pin from the front until it is flush.
Operating instructions SATA air vision 5000
Warning!
EN
83