Final Assembly - Emerson LUCERE CF575BQ00 Manuel Du Propriétaire

6.1
Screw the Two Threaded Studs (supplied) into the
Tapped Holes in the Hanger Bracket (Figure 28).
6.2
After Connections have been made, turn Wires and
Connectors upward and carefully push them into the
Outlet Box (Figure 29).
Position the Antenna Wire on top of the Receiver.
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
6.3
Lift the Ceiling Cover up to the Threaded Studs and
turn until Studs protrude through the Holes in the
Ceiling Cover (Figure 30).
Secure the Ceiling Cover in place by sliding
Lockwashers (supplied) over the Threaded Studs
and installing the Two Knurled Knobs (supplied)
(Figure 30).
Tighten the Knurled Knobs securely until the Ceiling
Cover fits snugly against the ceiling and the Hole in the
Ceiling Cover is clear of the Downrod.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.

6. Final Assembly

Figure 28
Figure 29
1-1/4"
THREADED
STUDS (2)
#8 EXTERNAL
TOOTH
LOCKWASHERS (2)
Figure 30
19
HANGER
BRACKET
THREADED
STUDS (2)
Please contact 1-800-654-3545 for further assistance
OUTLET BOX
RECEIVER
ANTENNA WIRE
CEILING
COVER
#8-32 KNURLED
KNOBS (2)
emersonfans.com
ETL Model No.: CF575