Final Assembly - Emerson CF279BS00 Mode D'emploi

6.1
Engage the Fan Motor 2-Pin Wire Connector into the
2-pin Wire Connector of the LED Light Fixture Assembly
(Figure 27).
The connection is complete when you hear a soft click.
6.2
Carefully tuck all the Wires and Connectors into the
Lower Housing.
Position the LED Light Fixture Assembly onto the Lower
Housing, aligning the Three Holes.
NOTE: Verify that the wires and connectors are not
trapped between the LED Light Fixture Assembly
and the Lower Housing.
Install and tighten the Three #6-32 x 1/4" Pan Head
Screws with Lockwashers (supplied) to complete
the installation of the LED Light Fixture Assembly
(Figure 28).
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the Lower Housing and the LED Light Fixture
Assembly.
6.3
Place the Shade into the opening of the Lower Housing,
aligning the Three Flat Areas on the top edge of the
Shade with the Three Raised Dimples on the Lower
Housing and turn the Shade Clockwise until it stops
(Figure 29).
NOTE: Periodically check that the Shade is seated
fully clockwise in the Lower Housing.

6. Final Assembly

FAN MOTOR
2-PIN WIRE
CONNECTOR
LED LIGHT
FIXTURE
ASSEMBLY 2-PIN
WIRE CONNECTOR
LED LIGHT FIXTURE
ASSEMBLY
Figure 27
LED LIGHT
FIXTURE
ASSEMBLY
Figure 28
LOWER
HOUSING
FLAT AREA
Figure 29
16
#6-32 x 1/4" PAN HEAD
LOWER
HOUSING SCREWS
W/LOCKWASHERS (3)
DIMPLES
(3)
SHADE
ETL Model No.: CF279