6.
CONFIGURATION PROFI
6.2
CONFIGURATION "PROFI" - CHANNELS (DES VOIES)
INPUT
CH. CNT.
CHANNE.
CH. F. r
OUTPUT
SERVIC.
6.2.1a
SETTING MULTIPLYING CONSTANT - CHANNEL COUNTER
INPUT
CH. CNT.
CHANNE.
CH. FR.
OUTPUT.
SERVIC.
6.2.1b
SETTING DIVISION CONSTANT - CHANNEL COUNTER
INPUT
CH. CNT.
CHANNE.
CH. FR.
OUTPUT.
SERVIC.
*
Revolution measurement function
If you set the division constant (invariable) for channel Ch. Fr. as an integer number (range 1...255), the measurement will be realised according to the
preset multiplications of revolutions/pulses. In reality this means that revolutions are measured precisely after a number of revolutions have been fully
completed, which results in an improved stability of the measured value. This mode is not suitable for higher frequencies, where it can increase the
measurement period. If you do not wish to use this mode, use a decimal number instead and adjust the multiplication constant apropriately. Please
6.
2.1B
pay attention to the time platform (TIME 1), which must must alow for adding up the 1...255 pulses within the set time period. ATTN! When this option
ČÍTAČ
is used in the QUADR mode, it may result in an error when the direction of revolution is reversed.
48 | MODE D'EMPLOI OM 653UQC
SET. C.
FILTER
FORM. C
SET. C
SCAL. C.
FILTER
DIV. C.
OFF. C.
FORM. C
SET. C
SCAL. C.
FILTER
DIV. C.
FORM. C
OFF. C.
Paramètres primaire de l'appareil sont con-
figurés dans ce menu
1
- multiplying constant serves for calculation of
input value to required display value
- by entering minus value the direction of
calculation is changed, i.e. we count down
- range: -0,00001...999999
-
!
If non-zero value is set in the "TIME" or "RTC"
mode in the "OFF. C." item, it applies that the
multiplying constant "SCAL. C." is negative
1
- division constant serves for calculation of input
value to required display value
- range: 0,00001...999999
-
NASTAVENÍ DĚLÍCÍ KONSTANTY - KANÁL
SET. C.
Setting calibration constant
FILTER
Setting the digital filters
FORM. C.
Selection of projection
format
SCAL. C.
Setting multiplying
constant - Counter
DEF
= 1
DIV. C.
Setting division constant
- Counter
DEF
= 1
H