Orbit Merret OM 653UQC Mode D'emploi page 38

6. CONFIGURATION PROFI
6.1.2b SELECTION OF MEASURING MODE
INPUT CLEAR
CHANNE. CONFIG
OUTPUT. EXT. I N.
SERVIC.
6.1.2c SELECTION OF MEASURING PERIOD/TIME BASE
INPUT CLEAR
CHANNE. CONFIG
OUTPUT. EXT. I N.
SERVIC.
38 | MODE D'EMPLOI OM 653UQC
SET. v . SINGLE
MODE QUADR.
M. TIME UP/DW
KEYS FILTER UP-DW
M. S TART TIME
M. S TOP RTC
SETTIN.
TYPE A
LEVEL. A
TYPE B
LEVEL. B
POLAR.
BACKUP
SET. v . 0. 5
MODE 1. 0
M. TIME 5. 0
KEYS FILTER 10. 0
M. S TART
M. S TOP
SETTIN.
TYPE A
LEVEL. A
TYPE B
LEVEL. B
POLAR.
BACKUP
DEF
DEF
MODE Selection of instrument
measuring mode
SINGLE Impulse counter/Frequency
measurement
QUADR.
Impulse counter/Frequency
measurement for IRC
encoders
- measurement on two inputs (A&B). Can display
count and frequency
- in this mode every single rising edge of singnal
A and B is included in the count
UP/DW UP/DW Impulse counter/
Frequency meter
- measurement on input A, (inp. B/direction). Can
display count and frequency
UP-DW.
UP-DW Impulse counter/
Frequency meter
- measures on inputs A (UP), B (DW). Can display
count and frequency
TIME
Mode „Stopwatch/timer"
RTC Mode „Stopwatch/timer" with
RTC backup
- not in standard equipment
M. TIME Selection of measuring
period/time base
- if you set measuring period e.g. for 1 s, the
measuring runs approximtely from 1 s to 2 s (1
s + maximum one cycle of measured signal).
If no signal arrives within 2 s it is taken that
the signal has zero frequency
- range of setting of the time base is 0,5 s to
10 s
- in the „RTC" regime with data projection the set
time defines the cycle of switching between
time/date, min. is 5 s, datue is displayed for
approx. 2,5 s