Orbit Merret OM 653UQC Mode D'emploi page 40

6. CONFIGURATION PROFI
6.1.2e SELECTION OF STOPWATCH/TIMER CONTROL
INPUT CLEAR
CHANNE. CONFIG
OUTPUT.
EXT. I N.
SERVIC.
40 | MODE D'EMPLOI OM 653UQC
SET. V. CONTIN.
MODE CONTAC.
M. TIME EDGE
KEYS FILTER RUN. S T. C.
M. S TART C. R UN. S T.
M. S TOP CLR. R UN.
SETTIN. CL. R U. R E.
TYPE A RUN
LEVEL. A
TYPE B
LEVEL. B
POLAR.
BACKUP
DEF
M. S TART Selection of stopwatch/
timer control
- time setting menu is accessible only in the
stopwatch/timer regime
CONTIN.
Stopwatch/timer is running
constantly if the instrument
is turned on
CONTAC.
Stopwatch/timer is running
upon contact making
EDGE
Stopwatch/timer is controlled
by the priming signal edge
- time is set off by the edge (by the signal passing
across the comparing level) and stopped by
the next edge
RUn . ST. C .
Stopwatch/timer is controlled
and reset by the edge of the
priming signal
- time is set off by the edge (by the signal passing
across the comparing level) and stopped by
the next edge
C. R Un . ST.
Stopwatch/timer is controlled
and reset by the edge of the
priming signal
- time is set off by the edge (by the signal passing
across the comparing level) and stopped by
the next edge
CLR. R UN.
Stopwatch/timer is reset and
set off by the edge of the
priming signal (when the time is not running)
CL. R U. R E.
Stopwatch/timer is reset
and set off by the edge of
the priming signal, the cycle is repeated with
every other edge
- regardles of whether the time is running or not
RUN
Stopwatch/timer is only set
off by the edge
H