Repair; Accessories; Troubleshooting - Festo EPCO 16 Notice D'utilisation

EPCO
9

Repair

• Send the EPCO to our repair service if required.
• Information about spare parts and accessories can be found at:
( www.festo.com/spareparts).
10

Accessories

Note
• Please select the appropriate accessories from our catalogue
( www.festo.com/catalogue).
11

Troubleshooting

Malfunction Possible cause
Running Tension
noises or
vibrations
Incorrect regulator settings
Resonance point of the actuator
Piston rod Loads too high
does not move
Ambient temperature too low
(increased breakaway torque in
initial run due to increasing
viscosity of the lubricants in the
spindle system)
Tab. 6
Festo – EPCO-Z6 – 1407b English
Remedy
Install the EPCO free of tension
(evenness of the bearing surface: ≤ 0.2 mm)
Lubricate the piston rod
( 8 Maintenance and care)
Modify travel speed
Modify control parameters
(in closed loop operating mode)
Modify travel speed or load mass
– Reduce load mass
– Reduce travel speed
– Send the EPCO to Festo for repair
– Reduce load mass
– Reduce travel speed
– Adjust ambient temperature
27