Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the split pin by pulling and turning it using pliers.
2.
Turn the handle one counterclockwise turn to increase pressure.
3.
Reinstall the split pin with a small hammer.
Figure 19: Removing the split pin
6.3.2
Gasket
It is important to replace the gasket with another having the same diameter and density to
maintain a good seal.
1.
Remove the door and place it face-down on
something soft like a cushion of rags or a
piece of carpet.
2.
Remove the old gasket from the door. Use
a screwdriver to scrape the old gasket
adhesive from the door gasket groove.
3.
Apply a bead of approximately 3/16" (5 mm)
of high temperature silicone in the door
gasket groove. Starting from the middle,
hinges side, press the gasket into the
groove. The gasket must not be stretched
during installation.
4.
Leave about ½" long of the gasket when
cutting and press the end into the groove.
Tuck any loose fibers under the gasket and
into the silicone.
5.
Close the door. Do not use the stove for 24
hours.
Figure 20: Installing the split pin
Figure 21: Door gasket
Page 27
Publicité
Chapitres
Table des Matières
