Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3

RADIO CODE PROGRAMMING (FOR RSD ONLY)

When using the ERREKA RSD plug-in receiver (decoder-free receiver, trinary code, 433Mhz), the radio code can
be programmed in the control panel itself, as explained below. In other cases, follow the instructions of the plug-
in receiver used.
The programming of the radio in total and pedestrian opening are independent. Different transmitters can be
used with different codes.
Total opening code programming
Pedestrian opening code programming
PROGRAMMING AND STARTUP
1 Connect the control panel power supply (SW1 in
ON).
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP4 in "ON"; DIP2, DIP3, DIP5 and
DIP6 in "OFF".
DL3 lights up.
4 Select the required code in the transmitter.
5 Press the channel to be used for total opening.
If programming has been carried out correctly,
DL2 flashes.
6 Place DIP1 and DIP4 in "OFF" (DL2 and DL3 will go
off).
7 Disconnect and reconnect the panel power supply.
1 Connect the control panel power supply (SW1 in
ON).
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP6 in "ON"; DIP2, DIP3, DIP4 and
DIP5 in "OFF".
DL3 lights up.
4 Select the required code in the transmitter.
5 Press the channel to be used for pedestrian opening.
If programming has been carried out correctly,
DL2 flashes.
6 Place DIP1 and DIP6 in "OFF" (DL2 and DL3 will go
off).
7 Disconnect and reconnect the panel power supply.
PUMA operator for sliding gates
55

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Puma pus400ecPuma pus400ecm

Table des Matières