Installation Instructions - Dual Retro-Fit Installation
STEP 8 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise to
raise or counterclockwise to lower the unit.
For front leveling, use a 7/16" open-end wrench.
Adjust height of unit to match installation cutout
opening 84". The unit should be level and plumb with
cabinetry.
Hex nut adjusts
rear wheels
Open-end wrench
adjusts front
leveling legs
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
STEP 9 FINAL EXTERNAL UNIT
PREPARATION
For proper case placement after leveling, the back
side of the top and side retro trims should be flush
with the cabinet surround on all sides.
Refrigerator
or Freezer
Retro Trim
Cabinet
Surround
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Secure the trims to the surrounding cabinets to
reduce excess movement to the top of the case
during normal operation.
1. Drill 1/16" pilot holes in the trim (4 per side, see
figure for approximate locations).
2. Drive #6 Phillips head wood screws into the pilot
holes.
NOTE: This step does NOT replace the anti-tip safety
hardware. Refer to Step 4 Installing Anti-Tip Bracket
and Step 7 Inserting/Securing into Cabinet Surround for
details on installing the anti-tip hardware. Repeat for the
second unit.
2 at the top
and 2 on the
side in each
corner
Open doors to make sure lights are on. If they are not
on, check to make sure the master switch is on.
Install front access covers by replacing 2 T20 Torx
screws on each cover.
Front Access
Cover
28
Master
Switch
T20 Torx Screws
31-49133-1