Step 3 Adjust Stainless Panel - Monogram ZIR300NPKII Mode D'emploi

Installation Instructions - Stainless Door Panel

STEP 3 ADJUST STAINLESS PANEL

Door adjustments will be
made with 12 set screws
provided. Each corner
of the door will use 3
adjustment set screws.
Use a 1/8" allen wrench
to install the set screws in
the order as instructed.
The set screws behind
the top and bottom
support brackets are
partially hidden.
Follow the next steps for set screw installation.
For flush mounting, inspect the gap between the panel
and cabinetry at the handle side.
If the vertical gap between the
cabinetry is smaller at the top
than the bottom, insert and drive
the vertical screw on the top
bracket near the hinge side until
the gap is equal along the entire
vertical section. (You may need to
slide the panel to realign the side
gap to 1/8".)
If the vertical gap between the
cabinetry is larger at the top than the
bottom, insert and drive the vertical
screw on the top bracket near the
handle side until the gap is equal
along the entire vertical section.
(You may need to slide the panel to
realign the side gap to 1/8".)
Set
Screws
Hidden Set
Screw
Set
Screws
Inspect the alignment at the top of the panel.
Adjustments can be made by turning the vertical
adjustment screws, equally, on the top of the panel
bracket (2 adjustment screws per panel).
Vertical adjustment screw locations.
If the panels do not lay flat, they can be adjusted.
Start by adjusting the top corners and then moving
to the bottom corners. Each corner can be adjusted
independently.
If the panel is too deep inside the
cabinetry, the panel needs to move
away from the unit. Install the
outermost horizontal screws in all 4
corners and screw in until panel is in
position.
If the panel is too proud of the
surrounding cabinetry,
needs to move toward the unit. Install
the innermost horizontal screws in all
4 corners and screw in place until the
panel is in position.
After the panel has been adjusted to the desired
position, secure the panel by first driving and tightening
the vertical screws at the bottom of the door brackets
and then drive and tighten the remaining horizontal
screws. ALL 12 SET SCREWS should be driven and
firmly tightened in order to properly secure the panel.
After the top and bottom door
panel brackets are secured
by installing / tightening all 12
set screws, use the Phillips
head Hi-Lo screw and square
washer to secure the center
mounting bracket.
48
the panel
Center
Mounting
Bracket
Square
Washer
Hi-lo
Screw
31-49133-1