Monitor Function - switel WTC 67 Série Mode D'emploi

Scanning for a channel
Signals are searched for in the eight channels in a continuous cycle. SCAN" appears in the display. If an active channel is de-
tected, the channel scan stops. Press the P button to enable radio communication.
Start / End channel scanning
¤ X
X/Y
¤
Sending ringing tones
The ringing tones indicate to other subscribers that you want to talk to them. A condition for this is that the other subscribers are
using the same channel.
‘
Selecting/Deactivating ringing tones
There are 5 ringing tones available for selection. To deactivate the ringing tone, select the OF" setting.
4 x ¤
X/Y, P

Monitor function

The Monitor function enables the search for weak signals on the channel currently set. If you receive an external signal, switch to a
free channel. Always communicate with other subscribers on a free channel to prevent interference.
¤ Y
¤
Dual−channel monitoring
It is possible to monitor a second channel with CTCSS code in addition to the currently set channel with CTCSS code.
Activating dual−channel monitoring
7 x ¤
X/Y, ¤
X/Y, P
Both channels are scanned for signals. If an active channel is detected, the two−channel scan stops. Channel scanning is resumed
when no signal has been transmitted on the channel for five seconds.
Press the P button to enable radio communication on this channel.
Deactivating dual−channel monitoring
7 x ¤
OF
X/Y, , P
Key tone on/off
6 x ¤
X/Y, P
Operating the Walkie−Talkies
Start channel scanning
Resume channel scanning
End channel scanning
The ringing tone is transmitted for 2 seconds
Open the menu
Select ringing tone and confirm it
Monitor the channel
End the monitoring function
Open the menu
Select the 2nd channel and confirm it
Select the CTCSS code for the 2nd channel and confirm it
Open the menu
End dual−channel monitoring
Open the menu
Select ON / OF and confirm it
35