Monitor Function; Service Hotline - switel WTE017 Mode D'emploi

Confirmation signal (Roger beep)
The confirmation signal is issued on releasing the P button. This signals to the caller that you have ended trans-
mission.
Selecting a channel
M
+ or ,, P
Channel
1
2
3
4
Searching for a channel
Signals are searched for in the eight channels in a continuous cycle. SCAN appears in the display. If an active channel
is detected, the channel search stops. Press the P button to enable radio communication.
Starting channel search
3 sec
SCAN
Resuming search for a channel
+ or ,
Stopping channel search
M
Transmit ringing tone
The ringing tones indicate to other subscribers that you want to talk to them. A condition for this is that the other sub-
scribers are using the same channel.
C

Monitor function

The Monitor function enables the search for weak signals on the channel currently set. If you receive an external signal,
switch to a free channel. Always communicate with other subscribers on a free channel to prevent interference.
M and +
M
Key lock
The key lock function prevents inadvertent modification of settings. When the key lock function is activated, the
icon appears in the display.
Activating
19
M and ,
Deactivating
20
M and ,
Setting the transmission power
The device is equipped with 2 transmission power options,
HI (= high) and LO (= low). The corresponding icon appears in the display.
2 x M
+ oder ,, P
5 In Case of Problems

Service hotline

Should problems arise with the walkie−talkies, please refer to the following information first. In the case of technical
problems, please contact our hotline within Switzerland under tel. 0900 00 1675 (cost with Swisscom at time of going to
print: CHF 2.00/min). In the case of claims under the terms of guarantee, contact your sales outlet. There is a 2 year
period of guarantee.
Activate Settings mode
Select the channel and confirm it
Frequency (MHz)
446.00625
446.01875
446.03125
446.04375
Start the channel search
Resume the channel search
Stop the channel search
Send the ringing tone
Start monitoring the channel
End monitoring
Activate the key lock
Deactivate the key lock
Activate the programming mode
Select HI or LO and confirm
Channel Frequency (MHz)
5
6
7
8
446.05625
446.06875
446.08125
446.09375
−