Brick And Baffle Installation - Napoleon S25 Manuel D'installation Et D'opération

Masquer les pouces Voir aussi pour S25:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

finishing
EN
4.3

brick and baffle installation

WARNING
!
Operation of the appliance without the bricks and baffles can result in excessive temperatures that could
damage the appliance, chimney and the surrounding enclosure.
With the appliance and chimney installation completed, move the bricks into place as illustrated below (Fig. 4-3).
Carefully pivot two "E" fibre baffles up onto the secondary air tubes as illustrated (Fig. 4-4). Installation
A.
of the baffles may be facilitated by removing the two front secondary air tubes (see "secondary
air tube" section). Ensure that the baffles are pushed all the way to the rear of the firebox, leaving a
minimum of a 1 inch gap along the front. This will allow the flue gases to escape the firebox. Ensure the
overlap joint is tight and the notch is facing towards the front.
important:
During installation, the baffles MUST be square with the fireplace as they may be a tight fit in between the
secondary air manifolds.
Install six "D" bricks along the front of the firebox. Ensure to follow the numbering sequence in the
B.
illustration below (i.e. D1, D2, D3, etc.).
Install eight "A" bricks and four "B" bricks along the bottom of the firebox, working from the back of the
C.
appliance forward.
Install eight "A" bricks along the left and right sides of the appliance.
D.
Install four "A" bricks and two "C" bricks along the back wall by pivoting the bricks up under the brick
E.
retainer.
note:
Place "C" bricks in the centre, with two "A" bricks on either side as illustrated (Fig. 4-3).
The fibre baffles are shipped inside the firebox. They must be removed from all special packaging prior to installation.
For further details about brick descriptions and part numbers, see "replacement parts" section.
A
A
A
A
A
A
D5
A
B
D1
D3
D2
D4
22
W415-2837 / B / 06.22.21
E
E
A
A
C
C
A
A
B
B
A
B
A
A
A
A
A
D6
Fig. 4-3
Overlap
Joint
A
A
A
Secondary Air Tubes (x4)
Some parts
hidden for clarity.
Baffles (x2)
(only 3 illustrated)
Fig. 4-4

Publicité

Table des Matières
loading

Table des Matières