5.3
ORNAMENTAL TRIVET INSTALLATION
Insert the ornamental trivet into the space on the appliance top.
5.4
PEDESTAL TRIM INSTALLATION (IF SUPPLIED)
Ensure that the pedestal surfaces are clean and dry; peel the protective backing from the trim adhesive.
Insert one end of the brass trim into one of the slots located in the pedestal and pressing fi rmly, proceed
around to the other slot. Cut trim to size. Attach the rear knockout plate (located inside the ash pan for
shipping purposes).
5.5
BRICKS AND BAFFLE INSTALLATION
OPERATION OF THE APPLIANCE WITHOUT THE BAFFLES CAN RESULT IN EXCESSIVE
TEMPERATURES THAT COULD DAMAGE THE APPLIANCE, CHIMNEY AND THE
With appliance and chimney installation completed, move the bricks into place for your appliance as
illustrated.
A.
Install the bottom bricks, working from the back of the appliance forward.
B.
Before installing the back bricks, loosen the screw holding the brick retainer and insure that it has
been moved forward. Install the six bricks along the back wall by pivoting the bricks up under the
brick retainer. Re-tighten the screw.
C.
Referring to the appropriate illustration for your appliance, install the fi rst two rows of side bricks as
shown. Pivot the fi bre baffl e into place with the brick retainer down and toward the outside of the
appliance. Slide the top row of bricks into place to support the baffl e. The baffl e must sit fl at on the
outside row of bricks as well as the fl ange on the manifold shield. Push the baffl e all the way to the
rear of the fi rebox, leaving a minimum of 1" gap along the front. This will allow fl ue gases to escape
the fi rebox.
D.
Install the 4 bricks along the front opening.
NOTE: Do not operate if baffl e and manifold shield are not in position.
WARNING
!
SURROUNDING ENCLOSURE.
TRIVET
KNOCKOUT
PLATE
TRIM
PEDESTAL
W415-1468 / A / 09.30.16
19
EN