BOB RAMBLER Guide De L'utilisateur page 8

BOB Gear by Britax
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, pull the release lever,
and pull the wheel out of the rear
wheel attachment bracket.
Front Wheel Installation
1� Remove Through Axle and Hex
Wrench From Storage Bag
Remove nut from through axle.
Nut Through
Axle
2� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 8.
6
3� Insert Front Wheel
4� Insert Through Axle
5� Tighten Through Axle
Hex
Wrench
Check the front wheel before
each use of the stroller to
ensure it is properly secured�
Failure to secure the front
wheel can cause the wheel to
vibrate, wobble, or become
detached from the stroller�
FALL HAZARD - Wheel can
detach and cause tip over� Pull
on the wheel to assure it is
securely attached�
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
Insert the through axle into the
fork and through the wheel hub,
then install the nut to the opposite
side.
Hold the nut in place, and use
the hex wrench provided to fully
tighten the through axle. Pull on
wheel to check that it is securely
installed and does not wobble.
Nut