Checking Tire Pressure; Adjusting The Tracking - BOB RAMBLER Guide De L'utilisateur

Checking Tire Pressure

Plastic wheels are rated to a
maximum tire inflation pressure of
30 pounds per square inch (psi).
The maximum inflation pressure is
embossed on the wheel next to the
valve stem.

Adjusting the Tracking

If stroller pulls left or right when
the front wheel is in jog mode and
stroller is on flat terrain, adjust
tracking as outlined in the following
steps.
1� Empty Stroller
Remove contents from low boy
cargo basket.
2� Remove Child From Seat
3� Check Tire Pressure
4� Set Stroller to Jog Mode
Slide swivel knob to right. Knob
will slide into downward position.
Rotate fork/wheel until it snaps
into forward position. See
Choosing Walk or Jog Mode at
left.
5� Place Stroller On Level Ground
Find a stretch of level ground
about 16 feet (4.9 m) long.
6� Align Rear Wheel Axles
Align stroller so rear wheel axles
are perpendicular to a straight
line.
16 ft (4�9 m)
90°
RAMBLER User Guide
7� Test Alignment
Push stroller straight forward and
release to see if stroller veers right
or left. Repeat push test several
times.
If stroller consistently pulls to
left or right, see Fine Tuning the
Tracking.
Fine Tuning the Tracking
If Stroller Pulls LEFT
If your stroller pulls LEFT, turn
tracking knob counterclockwise up
to one half turn.
Tracking Knob
If Stroller Pulls RIGHT
If your stroller pulls RIGHT, turn
tracking knob clockwise up to one
half turn.
Tracking Knob
REPEAT roll test and adjust as
needed until stroller rolls straight.
9