Transport, Storage & Cleaning / Regular Checks - TEUFELBERGER treeMOTION Mode D'emploi

TRANSPORT, STORAGE & CLEANING /
REGULAR CHECKS
7. TRANSPORT, STORAGE & CLEANING
The load-bearing parts of the harness are made of
Polyester, Polyamid, Aluminium, Dyneema
Operating temp range

+50°C to -30°C
Storage and transportation conditions
X
Compaction

Ventilation
X UV radiation

Dry and clean environment
Maintenance/Cleaning

Water (≤ 30°C)

Mild detergent

Gentle hand washing
Drying

Hang in well ventilated space (≤ 30C)
Applied heat (e.g. fire)
X
Disinfection

Water (≤ 30°C)

Ethanol
Corrosive substances
Keep away from corrosive acids, bases, liquids, vapours, gases etc.. If you think damage has
occurred as a result of contact with an agressive substance:
1. Quarantine the product and label it in an obvious way so that it can not be used by mistake;
2. Send as much detail as possible about your concerns to the manufacturer;
3. Do not use the product again unless the manufacturer replied (in writing) that it may be
returned to service.
8. REGULAR CHECKS
Checking the equipment at regular intervals is absolutely necessary: your safety de-
pends on the effectiveness and durability of the equipment!
Following each use, the product should be checked for abrasion and cuts. Also check it for the
14
®
X
Nibbling pests
X
Excessive moisture

+15°C to +25°C
X Sharp edged objects
Machine washing
X
Pressure washer
X
Direct sunlight
X

Duration (≤ 1 hour)

Rinse after disinfection

X ... OK
X ... not OK