Limitations Of Use / Security Information / Transport, Storage & Cleaning - TEUFELBERGER ERGO Serie Mode D'emploi

Place the accident victim either in a sitting or a
squatting position or, if the person is unconscious,
in a stable side position, if possible with the upper
body elevated (avoidance of heart failure due to
overly fast reflow of blood from the lower half of the
body).
LIMITATIONS OF USE
Never carry out work with this product if, as a result
of your physical and mental condition,
your safety might be compromised in scenarios of
normal use or in emergencies!
It is not permitted to make any changes or amend-
ments that are not expressly described in this
manufacturer's information manual. Those may only
be carried out by the manufacturer.
It is not permitted to use permanent marker pens or
stickers to add individual labeling/marking directly
to the textile components of these products, as the
chemicals contained in such pens or stickers can
compromise the strength of these materials.
TO BE OBSERVED PRIOR TO USE
Prior to every use, this product must be subject to a
visual inspection in order to verify its integrity, readi-
ness for use and proper functioning.
Once the product has been subject to a fall, its use
must be discontinued immediately. If the slightest
doubt remains, the product must be retired or may
not be used again until a duly compentent person,
having subjected such product to the required te-
sting and inspections, has approved its further use
in writing.
It must be ensured that the recommendations for
use with other components be met: all compon-
ents of the personal fall protection equipment must
have been certified and comply with the relevant
PPE standards. By combining pieces of equipment
in a way that will compromise the safe functioning
of one of these pieces of equipment or of the com-
bination as a whole, you will be putting yourself in
danger!
Ensure all neighbouring components are compati-
ble. Ensure all components are correctly configured.
Failure to do so increases risk of serious injury or
fatality. It is the responsibility of the user that a re-
levant and 'live' Risk Assessment is in place for the
work to be carried out which includes emergency
contingencies.
LIMITATIONS OF USE / SECURITY /
TRANSPORT, STORAGE & CLEANING
A plan of rescue measures that covers all fore-
seeable emergencies needs to be in place before
this product can be used. Prior to and during use,
rescue measures that can be executed safely
and effectively must be considered at all times.
TRANSPORT, STORAGE & CLEANING
The textile materials of our products consist of PA
or PES. The heat load must therefore never exceed
100°C. Chemicals may attack the material and cau-
se it to lose in strength. In case of reactions such
as discoloration or hardening, the product must be
retired for safety's sake.
The products much always be transported in
suitable packaging (protected from dirt, moisture,
chemicals, UV radiation, mechanical damage, etc.).
Conditions of storage:
� Protected from light (UV radiation, welding
machines ...)
� dry and clean
� at room temperature
� Not in the proximity of chemicals (acids, lyes,
liquids, vapours, gases, ...) and other
aggressive environments
� Protected against sharp-edged objects
For cleaning, use lukewarm water and mild-action
detergents. Then, rinse the equipment with clear
water and dry it prior to putting it into storage. Dry
the product in a natural way, not near fires or other
heat sources.
For disinfection, use only substances that do not
have an impact on the synthetic material and metals
used.
If you fail to observe these provisions, you will be
putting yourself into danger!
13