TEUFELBERGER treeMOTION Mode D'emploi page 12

REPLACEMENT PARTS / LIMITATION OF USE
part approved by the manufacturer. Before using the equipment again, be sure to verify that the
spare part has been replaced correctly. If you lack the experience, skills, and knowledge that
are necessary for this job, please consult a compentent person or the manufacturer.
Additional tests were carried out at TÜV with DMM small Axis swivel-SW 100 used on the rope
bridge instead of the green ring. The quoted swivel may therefore be used as an alternative option.
4.1. MOUNTING OF REPLACEMENT PARTS
Mounting of gear loops (included) on your treeMOTION / treeMOTION S.light
pic. 18
1) Cut tubing to required
lengths. Insert shock cord.
3) Tie stopper knot in the other end of the shock cord.
In this way you can customize your harness by installing gear loops anywhere between two
holes of the base material of the back pad or the leg loops.
5. LIMITATION OF USE
treeMOTION / treeMOTION S.light may not be used in fall arrest situations. Slack in the
climbing line should be minimised at all times. There must not be any chance of a free fall.
„Free fall" does, however, not mean e.g. slipping of the user´s feet. Be aware of the po-
tential for pendulum swings and manage the risk.
Never carry out work with this product if, as a result of your physical and mental condition,
your safety might be compromised in scenarios of normal use or in emergencies! Modifications
or additions to this product, apart from replacement of the spare parts as described above, are
unacceptable, unless done by the manufacturer.
12
pic. 17
2) Pass shock cord through base material of harness.
Tie stopper knot in one end of the shock cord,
leaving approx. 1 cm looking out of the end of the
knot. Cut the other end.
pic. 20
pic. 19