Activating/Deactivating Call Screening; Setting The Recording Parameters - Siemens Gigaset C590 Manuel De L'utilisateur

Operating the answering machine on the Gigaset C595 base
The answering machine immediately starts
in recording mode and records the call. The
time set for the ring delay (
ignored.
Activating/deactivating two-way
record
You can record an external call with the
answering machine.
¤
Inform the caller that the call is being
recorded.
§Options§
Open menu.
Two-way Record
Select and press
Two-way record is indicated on the display
by an advisory text and is added to the
answering machine list as a new message.
§End§
Press the display key to stop
two-way record.
The maximum recording time depends on
the memory available on the answering
machine. If the memory is full, you will hear
an end tone, the recording is aborted. The
call recorded up to that point is listed in the
answering machine list as a new message.
•
Activating/deactivating
call screening
While a message is recording, you can screen
calls via the speaker of the base and regis-
tered handsets.
Permanently activating/deactivating
call screening
¢ ¢
Ì
v
Call Screening
¢
Handset / Base (³= on)
§Change§
Select display key to activate/
deactivate the function.
Call screening can be simultaneously acti-
vated on the base and handset.
Deactivating call screening for the
current recording
You can deactivate the function on the
handset during the recording.
§Silence§
Press the display key.
38
¢
page 38) is
§OK§
.
•
Setting the recording
parameters
The answering machine has already been
preset at the factory. Individual settings can
be adjusted using the handset.
¢ ¢
Ì
v
Recordings
¤
Change multiple line input:
Length:
Maximum recording time. Select 1 min.,
2 min., 3 min. or Maximum. The default is
3 min.
Quality:
Select recording quality Long Play or
Excellent. If the quality set to high, the
maximum recording time is reduced. The
default is long play.
Ring Delay:
When the answering machine should
accept a call select: Immediately, 10 sec.,
18 sec., 30 sec. or Auto. The default is 18.
sec.
§Save§
Press the display key.
Information about call acceptance
In Auto mode, the following applies to ring
delay:
u
If there are no new messages, the answer-
ing machine accepts a call after 18 sec-
onds.
u
If new messages are present, the answer-
ing machine accepts a call after 10 sec-
onds.
When operating remotely (
the answering machine does not "pick up"
the call in approx. 15 seconds there are no
new messages (otherwise the answering
machine would already have accepted your
call). There are no call charges if you hang up
before the answering machine picks up.
¢
page 39) if