Set Save Mode - Lutron QSG-3PCE Guide D'utilisation

Set Save Mode

1. Enter programming mode (see page 12).
Main menu
2. Use the master buttons to highlight "Save
mode" and press the OK button to
Scene setup
accept.
Save mode
3. Use the master buttons to highlight the
save mode you would like. The save
Save mode
modes are listed and explained below.
4. Press the OK button. The info screen will
display a confirmation screen that your
Save always
save mode has been saved.
5. Exit programming mode (see page 12).
Saved
Saved
Save Modes
Save always (default mode) . . Quick scene programming mode; automatically save changes made to to lighting levels or fade time
Save by OK . . . . . . . . . . . . . . Zone adjustments are temporary unless the OK button precedes them
Save never . . . . . . . . . . . . . . . Do not save any temporary changes to lighting levels or fade time
Four scenes . . . . . . . . . . . . . . Zone raise/lower buttons are disabled (typically used for rented spaces)
Button disable . . . . . . . . . . . . Only the timeclock button, IR receiver, and wallstations can be used to make temporary changes
Note: Off scene can be changed only through scene setup in program mode. Save modes will change only the fade time in Off
scene settings.
R
(master raise/lower changes are temporary)
Master raise/lower buttons, wallstations, and IR receiver are still enabled for adjustment of light level,
but these changes are not saved
(typically used in a public space)
GRAFIK Eye QS System Installation and Operation Guide 28
®
Master
buttons
OK
OK
button